|
|
industrial DAMPERS |
This Damper System is for use in Industrial Ventilators where the ventilation performance may need to be reduced at certain times. The system offers the ability to stop at any position whilst opening or closing.
There is a gap of approximately 12mm around the circumference of the damper blade to allow air flow through the ventilator at all times.
The damper ring in installed under the base flashing. It will fit snugly into the up-stand and secured in place with rivets.
A power supply will be required at each position a ventilator is to be installed.
Available in; 150mm, 300mm, 600mm and 900mm
There is a gap of approximately 12mm around the circumference of the damper blade to allow air flow through the ventilator at all times.
The damper ring in installed under the base flashing. It will fit snugly into the up-stand and secured in place with rivets.
A power supply will be required at each position a ventilator is to be installed.
Available in; 150mm, 300mm, 600mm and 900mm
Specifications
Flap & Collar Material: 1mm Aluminium – 5005 H34
Motor Specifications - 12DC - 50/60Hz - 2Nm
Open Time: Approx. 15 seconds
Close Time: Approx. 15 seconds
Angle of Operation: 90 degrees
Functions: Open, Close or Stop
Remote Systems: Learning - one remote can operate any number of dampers
Transformer: Input 110-240V 50/60Hz
Flap & Collar Material: 1mm Aluminium – 5005 H34
Motor Specifications - 12DC - 50/60Hz - 2Nm
Open Time: Approx. 15 seconds
Close Time: Approx. 15 seconds
Angle of Operation: 90 degrees
Functions: Open, Close or Stop
Remote Systems: Learning - one remote can operate any number of dampers
Transformer: Input 110-240V 50/60Hz
Our Technical Customer Care team is here to help you with your order requirements and any technical questions you may have on this product contact sales@thehvacshop.co.nz
